CTS and CITS Turner mock test-2

 Turner mock test

Turner mock 

Nimi online test cts & cits objective: Types of questions and answers in iti turner mock test, Turner ncvt online mock test

 

1. 1. The sizes 4 to 12 apply to...

A) Standard taper pin
B) Jarno taper
C) Brown and Sharpe taper
D) Morse taper

ANSWER= (C) Brown and Sharpe taper

 

2. Which statement is NOT true about taper turning by form tool method?

A) Broad nose tool is used in this method
B) The tool is set on to work at a full taper angle
C) The tool is fed straight into the work
D) This method is used for short tapers only

ANSWER= (B) The tool is set on to work at a full taper angle

 

3. Which statement is NOT true about taper turning by tailstock offset method?

A) Long jobs can be tapered
B) Good surface finish can be obtained by automatic feed
C) External taper threads can be cut
D) Steep taper cuts can be made

ANSWER= (D) Steep taper cuts can be made

 

4. Which of these is NOT among the standard process chart symbols?

A) Operation
B) Inspection
C) Storage
D) Operator

ANSWER= (D) Operator

 

5. Why is the top of a workbench made of wood?

A) It can absorb shocks
B) It does not damage the finished components
C) Both of the above
D) None of the above

ANSWER= (C) Both of the above

 

6. Which of these is a direct measuring tool?

A) Try square
B) Steel rule
C) Straight edge
D) Ring gauge

ANSWER= (B) Steel rule

 

7. The least count of metric micrometer is .......

A) 0.01 mm
B) 0.05 mm
C) 0.10 mm
D) 0.50 mm

ANSWER= (A) 0.01 mm

 

8. While filing, clogging of teeth of file by chips takes place. This is called ...

A) Loading
B) Dressing
C) Pinning
D) Jamming

ANSWER= (A) Pinning

 

9. A double cut file is used for filing on ....

A) Wood
B) Leather
C) Steel
D) Hard board

ANSWER= (C) Steel

 

10. Which is NOT the quality of a good coolant?

A) It has high heat absorption property
B) It has good lubrication quality
C) It is chemically active
D) It has a high flash point

ANSWER= (D) It has a high flash point

 

11. What is used on a lathe to give depth of cut?

A) Compound slide
B) Top slide
C) By adjusting the tool
D) Cross slide

ANSWER= (D) Cross slide

 

12. The special gear of 127 teeth or 63 teeth may be used to cut metric threads in a lathe having British lead screw. It is known as ...  system?

A) Idler gear
B) Change gear
C) Translating gear
D) Compound gear

ANSWER= (C) Translating gear .

 

13. The front face of lathe chuck jaws is stepped. The purpose of these steps is to .....

A) Add appearance
B) Reduce weight
C) Have increased gripping power
D) Hold larger diameter workpieces

ANSWER= (B) Tapping

 

14. The swing diameter over the bed of a lathe is ............. the height of the center measured from the bed.

A) Equal to
B) Twice
C) One-half
D) Thrice

ANSWER= (B) Twice

 

15. A cemented carbide cutting tool wears out faster at...

A) Fast speeds
B) Slow speeds
C) Medium speeds
D) Very fast speeds

ANSWER= (B) Slow speeds