ITI Fitter Questions and Answers

 Fitter Questions and Answers  Part - 4

Fitter Questions and Answers 

ITI  Fitter Questions and Answers: Types of questions and answers in Fitter, iti fitter mock test, nimi bharat skill. 

 

1. 1. Which material is used to manufacture grade ‘B’ ‘V’ blocks?

A) Tool steel
B) Carbon steel
C) High-quality steel
D) Closely grained cast iron

ANSWER= (C) High-quality steel

 

2. Why the cutting faces of files are slightly bellied length-wise?

A) Get a proper grip over the workpiece
B) Filing flat surfaces is made easier
C) Permit clearance between file face and the workpiece
D) Ensure more pressure on workpiece while filing

ANSWER= (B) Filing flat surfaces is made easier

 

3. Why the hand taps are chamfered at the lead?

A) Aligning
B) Finishing
C) Strengthening
D) Gripping

ANSWER= (A) Aligning

 

4. Why surface plates are made of stress relieved good quality cast iron?

A) To prevent corrosion
B) To prevent breaking
C) To prevent distortion
D) To prevent thermal expansion

ANSWER= (C) To prevent distortion

 

5. What is the main advantage of the adjustable parallel block?

A) To set different angle
B) To set the different depth
C) To set different length
D) To set different height

ANSWER= (D) To set different height

 

6. Which is used to finish the resharpened divider point?

A) File
B) Grinder
C) Scraper
D) Oil stone

ANSWER= (D) Oil stone

 

7. Why chalk is applied to the face of the file?

A)To reduce excessive pressure Up to 1.2 %
B) To increase chip removed rate
C) To reduce penetration and pinning
D) To increase penetration and pinning

ANSWER= (C) To reduce penetration and pinning

 

8. What is the use of a bevel protractor?

A) Check the length
B) Set the workpiece
C) Measure the angle
D) Measure the depth

ANSWER= (C) Measure the angle

 

9. Why chalk is applied to the face of the file?

A) To reduce excessive pressure
B) To increase chip removed rate
C) To reduce penetration and pinning
D) To increase penetration and pinning

ANSWER= (C) To reduce penetration and pinning

 

10. What is the use of fine pitch hacksaw blades?

A) Cut soft metal
B) Cut high-speed steel
C) Cut high carbon steel
D) Cut conduit and other thin tubes

ANSWER= (D) Cut conduit and other thin tubes

 

11. Which vice is used for holding hollow cylindrical jobs?

A) Pin vice
B) Pipe vice
C) Hand vice
D) Bench vice

ANSWER= (B) Pipe vice

 

12. Calculate the tap drill size for the M10 x 1.25 system?

A) 8.8 mm
B) 8.7 mm
C) 8.75 mm
D) 8.65 mm

ANSWER= (A) 8.8 mm .

 

13. Why slight convexity is given on the face of the hammer?

A) To make effective striking
B) To avoid digging of the edge
C) To allow even load on striking
D) To prevent damage to the work surface

ANSWER= (B) To avoid digging of the edge

 

14. Why the hand taps are chamfered at the lead?

A) Aligning
B) Finishing
C) Strengthening
D) Gripping

ANSWER= (A) Aligning

 

15. Why surface plates are made of stress relieved good quality cast iron?

A) To prevent corrosion
B) To prevent breaking
C) To prevent distortion
D) To prevent thermal expansion

ANSWER= (C) To prevent distortion